Juno Beach homes sit on slab foundations with vented attics that pull hot, humid salt air straight into the cooling space every day of the year. When your air conditioning bill climbs or a room won't cool, the culprit is almost always air leakage and undersized or missing insulation in that attic, where ductwork bakes in 140-degree heat and moisture condenses on every surface.
Port St. Lucie Spray Foam Insulation has served Juno Beach (ZIP 33408) and the surrounding Treasure Coast since 2011. We seal and insulate attics, walls, crawl spaces and rim joists with spray foam and air sealing that stops the leak at the source. Our team arrives fully insured, measures every job on site, and provides a written estimate with R-value and thickness specifications before we spray a single board foot.
Spray Foam Insulation in Juno Beach (33408)
Juno Beach's coastal homes are nearly all single-story concrete block on slab, built from the 1980s onward, with their air handlers and ductwork running through vented attics. That attic is your home's biggest thermal weak point. Hot, humid air from outside finds every gap at the ceiling plane, the top plate, and around penetrations. Moisture driven by vapor pressure condenses on cool ductwork and insulation. Rooms at the far end of a duct run never reach temperature no matter how hard the system works. Your air conditioning bill reflects the cost of cooling an attic that was never meant to be conditioned.
Spray foam insulation seals the attic to the conditioned space below. Closed cell foam (from $1.20 per board foot) creates a vapor barrier and reaches higher R-values in tight spaces. Open cell foam (from $0.55 per board foot) is softer, more forgiving around obstacles, and lets moisture move if ventilation is in place. For Juno Beach's salt-laden humidity and slab-on-grade construction, we often recommend closed cell in the attic and along the rim joist where the foundation meets the wall. Our team has been installing both types across the Port St. Lucie area and Martin County for over a decade.
Our services in Juno Beach
- Attic Spray Foam Insulation in Juno Beach · Port St. Lucie's vented attics bake in Zone 2A heat…
- Closed Cell Spray Foam Insulation in Juno Beach · Closed cell foam adds rigidity and a vapor retarder in Port St. Lucie's humid…
- Open Cell Spray Foam Insulation in Juno Beach · Open cell foam expands to fill stud bays in Port St. Lucie's older Fort Pierce…
- Wall & Injection Foam Insulation in Juno Beach · Block wall cores in Port St. Lucie's 1980s through 2000s homes often sit…
- Crawl Space Spray Foam Insulation in Juno Beach · True crawl spaces are rare in Port St. Lucie since slab-on-grade construction…
- Rim Joist & Band Joist Spray Foam in Juno Beach · Rim and band joists show up mostly in Port St. Lucie's older raised homes near…
- Garage Spray Foam Insulation in Juno Beach · Garages in Port St. Lucie's block homes absorb summer heat all day before it…
- Metal Building & Barndominium Spray Foam in Juno Beach · Metal buildings and barndominiums across St. Lucie County sweat and bake under…
- Commercial & New Construction Spray Foam in Juno Beach · Small commercial buildings across St. Lucie County face the same…
- Insulation Removal in Juno Beach · Old attic insulation in Port St. Lucie's block homes gets packed with humidity…
- Insulation Replacement & Re-Insulation in Juno Beach · Replacing attic insulation in Port St. Lucie means dealing with ductwork…
- Air Sealing in Juno Beach · Humid air finds every gap in a Port St. Lucie ceiling plane during the long…
How a Job Works in Juno Beach
We start with a free on-site assessment. You tell us what's uncomfortable, what's expensive, and what you've noticed (damp insulation, condensation, a room that won't cool). We walk your attic, check the rim joist and any crawl space, look at existing insulation, and explain what has to happen. If old insulation is wet, contaminated or compacted, it comes out before any foam goes in. We do not spray over moisture.
On spray day, our fully insured crew sets up mechanical ventilation to manage fumes during cure. We mask off areas that need protection and spray the foam to the thickness and R-value your written estimate specifies. The work takes a few hours for a typical attic. We leave the space unoccupied for 24 to 48 hours while the foam cures and off-gases. Your home remains occupied; we ventilate the work area, not the whole house. After cure, the smell clears quickly with normal air exchange.
We clean up debris, remove masking, and walk through with you to confirm the work meets your expectations. Your property is left clean and ready to use.
Juno Beach attic foam typically runs from $1.50 per square foot for open cell or $1.20 per board foot for closed cell, depending on thickness and R-value. Wall and injection foam in closed-block homes costs around $2 per square foot. Crawl space work starts at $2,500 and scales with the area and depth. Rim joist sealing runs from $650. If old insulation has to come out first, add $950 and up depending on volume and contamination. The biggest cost factors are the area to cover, the R-value and thickness you need (set by code and your comfort goal), whether you choose open or closed cell, and what has to be removed before we spray. Call us at (772) 877-0850 for a free on-site estimate. We measure your space, specify the foam type and thickness in writing, and give you a firm price before we start.
✅ Written Estimates with R-Value & Thickness Specs, fully insured for work in Juno Beach and nearby areas.